My Scx10 can finally be revealed. (Bandwidth Warning, High Res Photos)

2 Months and I've finally completed my Scx10 Kit with lots of DIY stuff.

This was the previous topic,
https://sgcrawlers.forumotion.com/t1828-new-to-hobby-just-bought-an-axial-scx10-unlimited-rubicon-kit

I took about 3days to build the stock kit and slowly finding material to upgrade it.

Waterproofed but have yet to dunk it.

Standard items
7ch Air Radio, Axial 27t Motor, running 3S Lipo.
Axles and Transmission about 70% filled with Proboat Marine Grease,
Bearings packed in WD40 and surrounded with Marine Grease, very very smooth
Hot Glued tires to rims so i can pop them out in future.

Special Items
5W White LED Alloy Strip 150mm x 12mm (3s Compatible),.. Extremely Bright, lights up half my room with it.
DC esc for the 5W light, DHB JR2

DIY Section
Tiger Beer alluminium Heatsink for the ESC filled with Arctic Silver 5 and Marine grease... My ESC runs relatively cold !,
Airplane Brushless motor Mounts x4 for the "Lift Kit", Mild Droop setup, same stock up travel but added down travel.
Aluminium Plate under belly and solid axles
Light Box from tumb tack box, filled with marine grease and hot glue,
Coloured cellophane paper wraped lights in the bumpers.

Scale Drivers !!

Nice!!! I like your tiger beer can idea. When are you going to join us?

No Idea, I have no vehicle so perhaps only woodlands areas. There are still a few areas to touch up on before mudding, securing the light bar, mud guards and wiring all. I am only going to run it in dry conditions now.